Shearing Blade

Product Details:

The machine used is called a squaring shear, power shear, or guillotine. The machine may be foot powered, less commonly hand powered, or mechanically or hydraulically powered. It works by first clamping the material with a ram. A moving blade then comes down across a fixed blade to shear the material. For larger shears the moving blade may be set on an angle or "rocked" in order to shear the material progressively from one side to the other; this angle is referred to as the shear angle. Setting the blade on an angle decreases the amount of force required, but increases the stroke. A 5 degree shear angle decreases the force by about 20%. The amount of energy used is still the same. The moving blade may also be inclined 0.5 to 2.5°, called the rake angle, to keep the material from becoming wedged between the blades. However, raking the blade compromises the squareness of the edge.^[4] The machine consists of a shear table, work-holding device, upper and lower blades, and a gauging device. The shear table is the part of the machinery that the workpiece rests on while being sheared. The work-holding device is used to hold the workpiece in place and keep it from moving or buckling while under stress. The upper and lower blades are the piece of machinery that actually do the cutting, while the gauging device is used to ensure that the workpiece is being cut where it is supposed to be.

Additional Information:

• Delivery Time: 4-6 Weeks
• Packaging Details: Wooden

Product Details:

Hydraulic Shearing Machine Blade. Suitable for any reputed make Machine. As per customer requirement.

Additional Information:

• Item Code: 8488
• Delivery Time: 4-6 Weeks
• Packaging Details: Wooden Packed

Product Details:

Hydraulic cylinders get their power from pressurized hydraulic fluid, which is typically oil. The hydraulic cylinder consists of a cylinder barrel, in which a piston connected to a piston rod moves back and forth. The barrel is closed on one end by the cylinder bottom (also called the cap) and the other end by the cylinder head (also called the gland) where the piston rod comes out of the cylinder. The piston has sliding rings and seals. The piston divides the inside of the cylinder into two chambers, the bottom chamber (cap end) and the piston rod side chamber (rod end / head end).

Flanges, trunnions, clevises, and lugs are common cylinder mounting options. The piston rod also has mounting attachments to connect the cylinder to the object or machine component that it is pushing or pulling.

A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. The piston pushes the oil in the other chamber back to the reservoir. If we assume that the oil enters from cap end, during extension stroke, and the oil pressure in the rod end / head end is approximately zero, the force F on the piston rod equals the pressure P in the cylinder times the piston area A:

Additional Information:

• Delivery Time: 2 Weeks
• Packaging Details: Wooden Packing

Product Details:

Hydraulic Sheet Holding Cylinder for any reputed make Hydraulic Shearing Machine. As per Sample OR Drawing.

Additional Information:

• Item Code: 8466
• Production Capacity: 100
• Delivery Time: 2 - 3 Weeks
• Packaging Details: Wooden Packed

Product Details:

We are dealing in Sheet clamping cylinder.













We are dealing in Sheet clamping cylinder.

Additional Information:

• Delivery Time: 2 Week
• Packaging Details: Wooden